Recent content by properchopper

From the motorcycle world https://www.jpcycles.com/search?_utf8=✓&query=rubber+battery+box+mounts "Milwaukee Twins Heavy Duty Rubber Mount heavy-duty design has internal spring for durability under high loads"

Ryan, Welcome ! What you're missing is a dose of reality. Nothing to worry about - you may likely have been misled although you seem open minded and willing to hear from those that have been in this for some time. FWIW take a look at some of the world's best FE competitors going for world...

Here's some vids of the early 32 1/2" prototype I built for an RC Boat Modeler article that ended up being used for advertising on Remy's site. I never got it really dialed in because I really don't have any benchmark on what "dialed in" looks like .:rolleyes: This has an AQ 1800 motor for a JS...

This should help. If you're planning on using a motor like the OEM AQ 2030 a .150 cable is adequate. If you go 1/4 inch tube with teflon with the OEM sized motor, later on if you go larger motor you can pull the teflon and use a .187 cable.

Yo Mike from the vault for your memory-enjoy thoughts 😎

Bob, I'll get them out tomorrow. A little quality double side sticky tape is a good way to adhere BUT in the event they come off I've done the "no sinkum" mod (stuffed flotation inside 🙃

Bob, Send me your address ( PM here or e-mail to [email protected].) I'll get them out this week. Tony

I picked up an angle drive a long time ago. Added some length to the fin. Boat handled well but at the time (this was my third P-Ltd OPC) I still hadn't got the hang of tuning. This one split in two when I accidently drove it into the turn one death buoy at Legg Lake.

https://www.offshoreelectrics.com/proddetail.php?prod=ks-brass-tb-36

The boat in question will have a full P motor - 5000mah no matter how you cut it isn't enough for sprints PLUS a single 4S 5000 would need to be centered where there won't be enough room on the tunnel. 2 X 2S 5000 in series isn't sufficient either as above.

Did the same ( years ago) Attached Thumbnails "Click image for larger version.[/B] Name: DSC01084.JPG Views: 146 Size: 61.5 KB ID: 15572"]https://forums.offshoreelectrics.com/attachment.php?attachmentid=15572&stc=1&thumb=1&d=1482092953 "Click image for larger...

Who Knew ??

I would certainly agree that a responsible pit man is essential. Beyond that as I was just getting into the oval racing scene and learning the ropes I would , when possible, have Tyler G. pit for me. Standing at my shoulder I often felt that he was the driver, I was just holding the controller...

Get well Bro - Hope to see you & the Honda at the lake someday soon