Recent content by LeeWininger

grainger sells them as well. https://www.grainger.com/category/hardware/mounts-and-vibration-control/cylindrical-vibration-isolators?sst=4&ts_optout=true&searchQuery=rubber+isolators&categoryIndex=1

Printed some Skiff drivers in petg, bottom 12mm are solid. Would a 1/4"-20 tap cut threads clean enough for a nylon thumb screw?

I used double sided tape to tack the mounts into position before screwing into 2x4

Had some time and wanted to make better use of my racks in the trailer and shop. Designed and printed these mounts for the shop. https://www.thingiverse.com/thing:6492191

These motors can be a bear to refire hot or flooded..... that being said a 257 generally likes 2 L 1 H on carb settings

Tape it like Alan, and it doesnt need taken off very often. Acts like a hinge. Be aure to keep us up to date on magnets!

Hockey tape along front seam inside and out. O-ring latches on rear.

Anyone have a gas scale Allison file they wouldnt mind sharing?

Last I checked, My Phil Thomas GSH comes in at 16.5# RTR.

You get what you pay for... The TFL starters dont have a solenoid so all the amps go through the switch causing them to burn out. The motors themselves are also prone to burning up. Some guys get a few weekends out of one some a couple years... My shortest life was 4 starts of a .45. They denied...

how do you keep water out of it when you dunk?

Do you happen to have a water jacket for it?

I'll take the 7016/3

Sam what battery packs ya running?

Thank you!