Recent content by brad nichols

Help Support intlwaters.com:

  1. B

    Go .21 head button needing turned down to set squish

    I would not be a big deal to have someone with a lathe machine it down .015 and then you could shim it up. Brad
  2. B

    2021 NAMBA Nationals 50th Anniversary

    It would be nice to see other pictures of the racing and people there too!! Border was closed to us Canadians from attending. Brad:(
  3. B

    Sport .20 setup issues

    Does your header run inside of the pipe? If it does it will cause you problems. Brad
  4. B

    Go .21 head button needing turned down to set squish

    The head changes on long and short stroke engines. Brad
  5. B

    2021 NAMBA Nationals 50th Anniversary

    I would like to get in on the Raffle and was wondering if I could send you some money to get some? Brad
  6. B

    2021 NAMBA Nationals 50th Anniversary

    Hey Al can I send you some money for raffle tickets? Brad
  7. B

    Where to get a speed master 20 mono

    Go to the manufactures post and on page 2 speedster?vision boats Brad
  8. B

    Krylon rattle can primer??

    That is what I was thinking it stuck to the underside of the cowl nose OK and it was finished with #180 but looking at most of the posts people are using Kryion so I will pick some up and try it. The paint sat 3 days in an 80 degree shop. What do you think of the motor Frank? Brad
  9. B

    Krylon rattle can primer??

    No I don't use primer normally as the Endura will fill #180 grit but I did finish with #320 on the cowl Brad
  10. B

    Krylon rattle can primer??

    I have the Zipp tunnel and have painted the cowl with epoxy. Cowl was sanded any clean with lacquer thinner and base colour was applied. Taped off for trim and when trim tape was pulled the base came with it. I see a lot of people are using Krylon is this the best to use on the cowl? The rest...
  11. B

    New to hydro and need some help please

    Looks like you did a nice job cutting and fitting the mesh!! Brad
  12. B

    New to hydro and need some help please

    Lead shot if you can find it or steel mixed with epoxy poured into a hole in the sponson tips and taped over, then stand the boat on it's nose untill dry. Brad
  13. B

    Insane boss rigger

    Looks good!!
  14. B

    Parts to get rid of.

    Can't say I have had a problem ordering and getting stuff from Steve. Brad
  15. B

    Sport 40 Rebuild

    Micro balloons are for just filling holes is ok but if you want strength use the chopped fibre or cabosil and make it into a paste. Use some epoxy brushed on first then fill. Remember to V out cracks then fill with cabosil of fiber. Brad
Top