adam beck

So is there a big diffrence between needle bearing shaft and one with just journal bearings. I found needle bearings on Mcmaster car...

Thank you sir. I give them a ring I found the stuff on McMaster. I am a little nervous about threading a hardened shaft that small...

So i have been searching for a non flex boat prop shaft. The only set up i found was from Dumas. Grimracer adviced me to use a straight...

Cool deal Grim I missed your coment at the end of a previous post that said it wouldn't really matter. Thank again

Grim thanks for all your help this is awesome I have one more question then I am gonna start buying parts. What angle so the drive line...

Cool deal thanks so much Grim. I have one more question what kind of angle am I looking to get with the prop shaft.

Grim could you explain what a hard couple is. And with a hard shaft the only adjustment I would have would be something trim tabs if I...

Grim racer i appreciate the advice on the set up. What about center of gravity? Nothing is mounted yet so if a can set it up right the...

Sounds good hope to see you at a D2 race sometime there's a big race in Celina Ohio in August come check it out

Thanks Jeff I will do that. I am lucky we have a large round lake in the center of town that would be killer for rc boats. The park...

Thanks for the info guys. You guys recommend a place for the strut and rudder? I have looked at the speed master stuff. I am gonna make...

Something a little spicer but not crazy I have a couple 2s batteries 2 2200 mah and two 5200mah I have a 150 a 2-6s water cooled esc but...

I built one of them that's not complete yet I really want to run a four stroke engine in it always keep my eyes out for a decent used...

I have two 2s 5000mah packs so that works. Yes to the spicier side of things we have a large lake in the center of our town so I have...

Hello guys not sure if this is the correct place but I need some help. I originally planned to run a nitro motor but have changed my...