Sullivan 12 volt Hi-Tork engine starter with ends to plug into a power panel or put alligator clips on to connect directly to a battery. Tested and works. Price is $25 + shipping in US but will ship worldwide for more postage.
S601 – Deluxe Hi-Tork Starter 12 Volts with a maximum of 80 Amps...
I gave a guy in California a shipping quote on it and it was over $60, but someone in Michigan it would have cost them a little over $18. All depends where you live.
With the case the $50 + shipping is the best I can do. Don't want to split it up as I already tried selling the case separately and it didn't sell. Give me your zipcode and I could give you a shipping quote. That case will also hold up to four pistol weapons.
JR XR3i FM 75 mhz radio with a 4 model memory and channel 66 crystals.Comes with a JR R135 receiver,and a MPI charger that charges the TX and Rx at the same time and a manual. Also comes with a case that holds two pistol radios. Hitec stickers can be removed easily. $50 + shipping
SOLD......This is a two sheet plan for the Bob Stark Class C runabout. The hull is 28" and can be powered by a 3.5 outboard or an electric conversion on a 3.5 lower leg. Also included is the build article detailing the materials and build instructions. $15 + shipping.
The site will be closing soon so if anyone that does scratch building should download any the plans that interest you in that section onto your computer. After on your computer you can put them on a disc. Also there's some good info in the articles section. http://www.modelpowerboat.com/content.php
Would anyone have traced the frames diagram for the 36" Dumas SK Dadddle ? I have the build plan but it doesn't show each frame that goes into the boat.I don't know how many of you do this.I trace the parts from a kit on 36" wide plan paper so if I want to scratch build or need a damaged part I...
Thanks everyone for the replies. I sold a K&B 3.5 cut for an electric conversion to a guy and gave him this prop shaft assembly in case he wants to try to fix it.
I didn't have a small enough punch so I used a small allen wrench and tapped it out. The unit had a lot of wobble in it and I thought I might be able to put a brass sleeve in it to take the wobble out.This little prop shaft assemblies are costly so I thought I might be able to rebuild it.
Anybody know what size allen wrench the set screw on the drive dog on a K&B 3.5 cc outboard takes ? I looked on Mecoa's site but found no info about it.