Jump to content
Roxyflash

Setting timing on a CMB alpha 27

Recommended Posts

Using a dial indicator set tdc to zero then the letter says to set timing to 1.2 to 1.5 line on rotor lines up with line on stator.I set it to .130 lining up the marks is this correct

Share this post


Link to post
Share on other sites

Buckshot is right on setting.   CMB makes a dial indicator that screws into plug hole for doing this.  Makes it much easier for measuring proper setting.  I have these in stock.  However, I am going to be gone for 10 to 12 days.

Stu

Share this post


Link to post
Share on other sites
37 minutes ago, Stuart Barr said:

Buckshot is right on setting.   CMB makes a dial indicator that screws into plug hole for doing this.  Makes it much easier for measuring proper setting.  I have these in stock.  However, I am going to be gone for 10 to 12 days.

Stu

Bring me one of the dial indicators please.

Share this post


Link to post
Share on other sites

It's easy to make an indicator holder from an old plug.  Cut out the insulator and turn a press fit piece with a hole for the indicator.  Add a screw for retention.

Lohring Miller

Timing measurement.JPG

Edited by LohringMiller

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×