Prop Balance

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Andy Brown, Mark Sholand etc.
default_tongue.png
default_biggrin.png
default_laugh.png
 
Guys,

One thing that may get overlooked is the blade lengths out from the hub.

I put them on a metal lathe and even up the blades. You will find that this

will correct a lot of balancing problems. I would wear exam gloves while

touching propellers, most things that you touch get absorbed into your skin

and get passed onto your kidneys. Also, the best dual cartridge 3M respirator

you can afford. Balancers that I use are Frank Orlic's, but there are some other

very good ones on the market now. I use a stub shaft with a drive dog in my lathe

chuck, it works Very Well for me. You could also buy a good pair of digital calipers

and measure from the inside of the hub out to the blade tips. Just a few other tips

that might help you.

Thanks For Reading,

Mark Sholund
 
Thanks Mark.

Guys,

One thing that may get overlooked is the blade lengths out from the hub.

I put them on a metal lathe and even up the blades. You will find that this

will correct a lot of balancing problems. I would wear exam gloves while

touching propellers, most things that you touch get absorbed into your skin

and get passed onto your kidneys. Also, the best dual cartridge 3M respirator

you can afford. Balancers that I use are Frank Orlic's, but there are some other

very good ones on the market now. I use a stub shaft with a drive dog in my lathe

chuck, it works Very Well for me. You could also buy a good pair of digital calipers

and measure from the inside of the hub out to the blade tips. Just a few other tips

that might help you.

Thanks For Reading,

Mark Sholund
 

Latest posts

Back
Top