- Joined
- Jun 11, 2009
- Messages
- 1,549
Hi All,
I may not get any feedback on this but that is ok, just trying to do better.
Hope this is the right forum (if not im sure Don will fix lol)
I have produced 300 SS drive dogs to which approx 60 have been sold.
The other 240 are going through final machining and dress up.
They have been beefed up a little by length, dia, and tongue width along with a single flat set screw.
I don't have a list of who have purchased yet but would like feedback on if they are good to go or need some sort of improvement.
Below is a finished one of the 60.
The specs are a bit secret but if you have purchased one you know what final improvements need to be.
Thanks
Tim
I may not get any feedback on this but that is ok, just trying to do better.
Hope this is the right forum (if not im sure Don will fix lol)
I have produced 300 SS drive dogs to which approx 60 have been sold.
The other 240 are going through final machining and dress up.
They have been beefed up a little by length, dia, and tongue width along with a single flat set screw.
I don't have a list of who have purchased yet but would like feedback on if they are good to go or need some sort of improvement.
Below is a finished one of the 60.
The specs are a bit secret but if you have purchased one you know what final improvements need to be.
Thanks
Tim
Last edited by a moderator: