ESC Issue

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Chris Thomas

Well-Known Member
Joined
Nov 10, 2002
Messages
464
Hey guys. Having an issue with ESC control. getting ready to setup a P Limited Hydro. bench tested my motor esc and battery. I am using flycolor 150A ESC, a 4S batt and aqua craft motor. I can get the gear to run using a servo tester for signal to the esc. But when trying to use the radio i cannot seem to get it to sync up correctly. I have tried to re cal esc to the radio, tried both Futaba 4GRS and a Hitec Agressor. No luck with either. Whats the trick...?IMG_20170709_224815611.jpg

https://youtu.be/-FYRALL9yrk
 
Last edited by a moderator:
I have figured out the problem. Since it was the initial setup. the directions were calling for the throttle range setup. At the start of the power up sequence. Move throttle to full on, wait for two beeps etc. Followed instructions problem is throttle channel was reversed so it never seen a high. Neutral (off) position and a lower signal. No call to turn on....
 
Back
Top