Jump to content
Sign in to follow this  
David Ashcroft

Mono

Recommended Posts

yeah, looks very much like a Youngblood mono (similiar to the boat in my avatar). I purchased my Youngblood mono's through Tidewater back in the day.

 

They came:

31.5 inch length (3.5cc/.21)

38.0 inch length ((7.5cc/.45ci - 11.00cc/.67ci)

40.0 inch length (13.00cc/.80ci - 15.00cc/.90ci)

 

I'd be curious to see an image of the bottom

Share this post


Link to post
Share on other sites

This hull had a terrible surface ,so now its sanded nice and flat as level as can be.

Also cut the deck off and going to chop the freeboard 3/4" to give it a sleek dragboat look.

Will sand the inside now and reinforce with carbon.

wow. At this point you may want to consider carefully replacing the engine rails.

 

I'm curious, what did you use to cut deck off with? A moto-tool?

Share this post


Link to post
Share on other sites

Inside all sanded back,sizing up the carbon ,and cutting new transom ply and stringers.

nice Dave. I assume you will be using polyester resin for lay-up?

Edited by David Bryant

Share this post


Link to post
Share on other sites

Yes David a dremel with cutoff wheel,and yes better replace the stringers ha.

yeah, I have another original (brand-new) Prather deep vee hull that I've been planning to do the same- ie. cut-off deck, trim free-board lower, then re-build new deck using plywood bulkheads and sheeting.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×