tool time

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Steve:

Verey nice tooling. Simple and super effective.

Do you use loctite when you re-assemble? How much press does the CMB crank pin have?

Have you done any Gas Engine Cranks that way?
 
clueless on the amount of press.i don't use locktite,the fit is so smooth and tight I think locktite would just push out into the bearings,and do no good. I have seen some of the 67 and 1.01 cranks move apart,but never seen any twist. only done rs 45,67,and 91/1.01 cranks.this tool was made for a customer to do the 27 cc gas cmb cranks,it's not mine
 
Back
Top