Jump to content

tnrcboatracer

Members
  • Content Count

    2,404
  • Joined

  • Last visited

About tnrcboatracer

  • Rank
    World Racer

Contact Methods

  • Website URL
    http://

Profile Information

  • Gender
    Male
  • Location
    Chattanooga, TN

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. tnrcboatracer

    Futaba 4pk with 3 receivers

    Dang it David... beat me to it. I lnow David will complete his purchase, so no need for me to get in line..... Sent from my SM-N920V using Tapatalk
  2. tnrcboatracer

    THE BEAST!

    Hreat. I had no idea hoe much torque a 67 produced. Sent from my SM-N920V using Tapatalk
  3. tnrcboatracer

    THE BEAST!

    I think that oil mist lube is lowest friction, but drip is a close 2nd. Just make sure that bearing doesn't fill with oil. Need to have a way to shut off oil when not turning Sent from my SM-N920V using Tapatalk
  4. tnrcboatracer

    THE BEAST!

    GMN also has models that are sealed with grease or oil lube. Sent from my SM-N920V using Tapatalk
  5. tnrcboatracer

    THE BEAST!

    The FN 437 M has a keyway, 15mm shaft, and is rated at 176 Nm. https://www.gmnbt.com/sc-fn-437-m-complete-freewheel-clutch.htm Sent from my SM-N920V using Tapatalk
  6. tnrcboatracer

    THE BEAST!

    I prefer taco oil mist lube, but that is a little more expensive. Sent from my SM-N920V using Tapatalk
  7. tnrcboatracer

    FUTABA T4PKSR + 2 rx's

    Will you take $220 shipped to TN 37160? Sent from my SM-N920V using Tapatalk
  8. tnrcboatracer

    THE BEAST!

    Terry, is 13.5 Nm torque capacity enough? The GMN FP427Z sprag clutch has 94 Nm torque capacity. Sent from my SM-N920V using Tapatalk
  9. tnrcboatracer

    Zipkits Outboard Rigger

    Not sure if it matters, but I didn't see a cavitation plate on Mic's setup. Sent from my SM-N920V using Tapatalk
  10. tnrcboatracer

    ABC props for sale

    Hey Walt, you still got a 1615-20? Sent from my SM-N920V using Tapatalk
  11. tnrcboatracer

    Auctioning Sonny Barrett's Boat and Parts Collection

    I'll bid $175 and will pick up one weekend in Huntsville Sent from my SM-N920V using Tapatalk
  12. tnrcboatracer

    looking for WIS bearings

    didnt seer any new pm's, but i am here. Sent from my SM-N920V using Tapatalk
  13. tnrcboatracer

    looking for WIS bearings

    Didn't see your pm. Let me go check again. Sent from my SM-N920V using Tapatalk
  14. Yes, i still carry and sell the Swiss and German bearings. Sent from my SM-N920V using Tapatalk
  15. Hey Ron. I think i missed this post. Please IM me if you still needed these bearings. I have plenty of stock. Sent from my SM-N920V using Tapatalk
×