Jump to content

P THOMAS

Members
  • Content Count

    4,015
  • Joined

  • Last visited

About P THOMAS

  • Rank
    World Racer
  • Birthday 06/12/2000

Contact Methods

  • AIM
    supersport45
  • Website URL
    http://www.philthomashydros.com
  • ICQ
    0

Profile Information

  • Gender
    Male
  • Location
    Decatur, IL

Recent Profile Visitors

3,200 profile views
  1. P THOMAS

    1/8 Winston Lobster Tail

    thats good for the angle, still use some epoxy to seat the tube
  2. P THOMAS

    1/8 Winston Lobster Tail

    Looking good, You can setup the rear sponsons on the marks with the depth in the info, you can slot the rear hole to aid some adjustment, same with the wing bodies you can change the angle of attack there too. The frontsponson angle was close with the front tube where it is now but follow the setup info and make the hole bit bigger then use the 1/4 stick under the pads to be sure both sponson equal angle, use some epoxy to seat the front tube in place. There more work to do with this kit like make a turbine tube and that rear wing aluminum brace. Many ways to mount the cowling part too, I usually make a ply base to make the fit easier and stiffen it up some.
  3. P THOMAS

    FUTABA T4PKSR + 2 rx's

    Hey Corey, trade you a Stealth sport 21 hydro for the radio.
  4. P THOMAS

    Celina Summer Challenge

    Do you have any block of rooms? everything shows full.
  5. P THOMAS

    Phill Thomas Stealth 45

    The Grim racer cowl latches from tower hobby have been discontinued, really liked those latches. i have found that the small hatch latches from Zipp mfg will be a good replacement.
  6. P THOMAS

    Phill Thomas Stealth 45

    Thanks Jim, the Bud turbine cowl was packed loose in the box and it may not fit tight to the hull. Here another tip If your turbine cowl is not fitting close to the hull you can run hot tap water over those epoxy cowls and they will soften up, then tape it down till it cools. This works best with the fresh new cowls after a time the parts will cure more and will not change.
  7. P THOMAS

    IMPBA 2019 Internats

    posted where,what changes?
  8. P THOMAS

    IMPBA 2019 Internats

    Will this be on the online signup websites or do we have to fill out and mail the entry?
  9. P THOMAS

    Marine Specialties rudder strut combo

    ok paypal to my email address,,, note you shipping address
  10. P THOMAS

    abc 2317

    Paid
  11. P THOMAS

    abc 2317

    i will take this prop
  12. P THOMAS

    Marine Specialties rudder strut combo

    I have one of the strut assy. and extra T mount I you want it,, $20 shipped
  13. P THOMAS

    Titanium Rod NIP

    no it is an older disc valve motor
  14. P THOMAS

    Titanium Rod NIP

    I have a Rossi 65 to go with those rods if you would like to buy another. $50 shipped
×