Rebuild zipkitt 12 rigger

[Roxyflash]

This boat was a mess the epoxy never cured right was gummy they didn’t paint the boat but has been run.The sponson had the brass tube broke off so they glued the sponson to the rod.When I tried the remove the sponsons from tub ended up pulling 3 of the 4 brass tubes out of sponsons plus it pulled the brass tubes out of the tub.Replaced the broke one I sanded the tubes on a disk sander to give the epoxy something to stick to.The carb had a straight nipple so the fuel line ran out side the cowl back into it by the tank which had a manual needle vavle hanging out side of cowl.Put new sponson rods on it ordered a new cowl.Cleared the tub painted the cowl and sponsons.I painted it like the warlock for Adam .Doesnt look like the same boat.

 

[douglong]

Great work Bruce

 

[adam larvenz]

should be fun to run it now if i get it as good as it looks she'll fly thanks bruce