Kris Flynn
Well-Known Member
- Joined
- Mar 11, 2002
- Messages
- 4,354
Who are the people in the know who I can bounce some questions off RE sport hydro design? Not looking to bend the rules, but want to make sure that what I want to do does not fall outside the rules.
it is regarding double sided taping on sponsons to a center tub, which would mean the inside edge of the sponson in the picklefork would technically be 1/32" or so outside the sides of the "tub" as per the rules I am unsure if this is OK? Pretty sure not.
Also, has someone got a sketch that clarifies this section for me from the IMPBA rulebook
Section 4, A 10
Belly pans are allowed but must terminate aft smoothly and extend no further than 50% of the aft plane. Belly pans must be at least 3/8 inch above the bottom planning surface of the boat measured with the boat resting on its 3 points on a static table
cheers
Kris
it is regarding double sided taping on sponsons to a center tub, which would mean the inside edge of the sponson in the picklefork would technically be 1/32" or so outside the sides of the "tub" as per the rules I am unsure if this is OK? Pretty sure not.
Also, has someone got a sketch that clarifies this section for me from the IMPBA rulebook
Section 4, A 10
Belly pans are allowed but must terminate aft smoothly and extend no further than 50% of the aft plane. Belly pans must be at least 3/8 inch above the bottom planning surface of the boat measured with the boat resting on its 3 points on a static table
cheers
Kris