About Octura (M575 and P775) M and P serie

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Rickard Andersson

Well-Known Member
Joined
Feb 17, 2012
Messages
127
Have any one bin using these props (M and P), the M serie is a low lift (I think) and the P serie I do not know anything about. What mods do these props need to work, do you pitch/cup or cut them like a 1400, 1600 or X serie prop?

Thanks Rickard
 
Walt, It's for my gas boats, one mono is 53" and powerd by QDP 27 and the other is 58" and powerd by QDP 29,5. These props are new to me, was thinking of to try them.

Rickard
 
Walt, It's for my gas boats, one mono is 53" and powerd by QDP 27 and the other is 58" and powerd by QDP 29,5. These props are new to me, was thinking of to try them.

Rickard
I think these props will be to small foir a gas engine, might be better to go on the the Dock, Jims dock and most on there are Gas guzzlers.

Walt Barney
 
Rickard,

They will work just fine after you pitch and profile them.

Actually a 75 mm propeller may be a touch too large for your application.

Good Luck Testing,

Mark
 
Last edited by a moderator:
The M Series props are just like the X series props but have some of the tongue area removed.
 
Back
Top