.90/1.00 Seaducer

[Buckshot]

44" Seaducer SD3 .90/1.00 mono.

Built in 2006.

Orange on Orange.

All Seaducer Hardware - Motor mount, strut, rudder, turn fin, pipe mount.

CMDi needle valve on C/F mount.

Sullivin Tanks with Aluminum stoppers.

CMDi drive shaft - 1/4" to 1/4" stub, and I think I also have 1/4" to 3/16" stub (I'll check tonight)

Set up for CMB Evo 2000/2002.

Ran maybe 5 times, and never heat raced.

Runs really well. I didn't have any hooking problems with it going through the corners.

I'm just not a mono kindda guy I guess so might as well sale it to someone who will enjoy it.

$425.00 plus shipping.

Photos can be seen ----->HERE<-----.

ALL RADIO GEAR IN THE PHOTOS IS NOT INCLUDED!! i.e. no servos, Rx, or battery pack.

Regards,

-Buck-

 

[Buckshot]

I do have both drive shafts for this boat.

1/4" to 1/4" stub

and

1/4" to 3/16" stub

-Buck-

 

[Tom Foley]

A few questions , Is it Gelcoat or paint , is the mount down as low as possible , and how is the tank tray bonded in . Thanks , Tom .

 

[Rc1racing]

Pm sent.

John

 

[Buckshot]

A few questions , Is it Gelcoat or paint , is the mount down as low as possible , and how is the tank tray bonded in . Thanks , Tom .

It is gelcoat from Seaducer

Mount set per destructions

Tank tray is bonded with JB Weld

-Buck-

 

[Buckshot]

Pm sent.
John

Reply sent

-Buck-

 

[Rc1racing]

Pm sent.
John

Reply sent

-Buck-

PM replied

John

 

[Buckshot]

Sold to John Pending funds.

-Buck-

 

[Rc1racing]

I'll get the money order mailed out Monday.

John

 

[Rc1racing]

Money order sent.

John