Search results

Thanks Mike got the cowl painted should have went another round of filling the pins holes but ran out of primer didn’t want to buy more so I painted it.Waiting on flex shaft to show up other wise it’s done.

With help from Mark I was able to get a header it was 18 degree so I had to bend it turned out good.The pipe was same diameter as the header pipe so I used my wirsbo expander.Got the cowl primered next I need to paint it.Wheres the best place to buy the header spring?

I just sent out the rudders and servo if I would of known you were interested I would have threw it in for free it’s only good for parts

The orange layed down nice.Looks good a little orange peal don’t hurt some new cars have that effect.

Sent you a pm

Took this on trade for ready to run gas mono fun boat.Had a water blast pickup and giant scale servo.Put a regular water pick up rudder on it.I didn’t like the linkage on the giant scale servo so I put a standard size servo with straight tig rod linkage.The boat had a Teflon liner for flex shaft...

Not sure what brand these rudders are there’s no water pickup on them.S3303 giant servo tested works 40 shipped

Are you going to clear over it with some ureathane?

Looks good what paint you use?

Need one for a rigger

If you eat the 2% cottage cheese that’s enough to made you puke!Should be square with all the angles and blocks!

Sold to Frank

I have a old 23 two transfer short block for parts if needed

Have some left over starter parts for sale.These are used for the homemade style starters.Two small solenoids two push buttons.30.00 shipped

Hopefully will be able to hookup be nice if all us can make it out!

Looking good can’t wait to see it running at the lake won’t be too long now

Is the receiver upside down I did this on my scratch built rigger 304sb and hasn’t had a issue is this right or wrong?

When I installed the pool noodles I found some solid 2 1/2 inch noodles they fit in the bottom perfect then I used the standard 2 inch hollow noodles on top of the 2 1/2 I also surrounded the front with the 2 inch.I also used 3/16 tig rod for rudder linkage.I found a heavy duty o ring for radio...

I see you must of liked my tank mount theory hope to get a speed on my f41 yours looks great i tried a zip prop 6717/3 my cmb didn’t like it put a 2714/3 chopper on it was really fast got my gps in it and put a zipkitts pipe on it had a vision pipe I have a couple other props to test.I also...

Are these zenoah coils or aftermarket?