Search results

Does anyone know does OSE have a actual phone number. Thanks in advance.

So whats everyone running for mah batteries for 1/8 Scale. I do have a set of 9500mah but is that over kill. Would 6500mah do the job ?

What is everyone using for upgrade 6001 bearing for zenoah with a radius on bearing were it meets crankshaft

Will gas harm phenolic retainer in a bearing ?

Got some water time with new Fe Scale. ESC never got over 96 degrees, motor 123 at ends of motor. Ran 8 hard laps two cool down laps, prather 250 turned down to 57mm. (stupid rule) 27500 rpm. Maxed out at 175 amp draw. 9500mah had 40% left. Not sure if these number are good or bad i have never...

So with all the new FE Scales being built what are we for ready to run weights ? What about the veterans that have been running for years stepping up on this. Thanks

Do lipos off gas or can they be used in a seal environment.

Anyone going to have savox servos for sale at the Melbourne race next weekend. Looking for 2 sw0231mg and 1 sw0250mg. Thanks in advance

As the air density continues to drop (eg 100 down to 90) Kinsler's states that for every point their is a lose of 2% power. So a loss of 20% power =smaller prop, lengthen pipe. I guess my question is "would going to a smaller head button and increasing compression ratio help ? I know what has...

Anyone have the rod length handy cmb beta .21

Working on a mold for a new sport 20 hull. What rudder servo are people using?

Hear are a few shots of new scale