Search results

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    Need a wrist pin retaining ring for a OPS80

    Ok I lost it. I didn't put it away the way I should have. Does anyone know where I may be able to get another. It looks like the outside of the wrist pin is .235" . Thanks
  2. P

    Looking to purchase a CMB

    In a previous topic I was looking to correct a carb problem with a OPS80. I burned up the motor and am now looking for a new CMB. The following people were listed as possible sources for these motors: allrc is a distributor in Washington State Stu Barr is the national distributor Jim...
  3. P

    Changing from Nitro to Electric

    Believe it or not I just burned up my nitro motor. I believe it is time to look at electric. Who can I start talking to? I believe I have far too many questions to try to include them on a great forum like this. Thanks Pat
  4. P

    Changing from Nitro to Electric

    Believe it or not I just burned up my nitro motor. I believe it is time to look at electric. Who can I start talking to? I believe I have far too many questions to try to include them on a great forum like this. Thanks Pat
  5. P

    I fried my OPS80 so fast?

    I have Googled several different thing to find replacement parts for my OPS80. I tried RC Nitro Marine engine parts, RC Nitro Marine engine as well as many more. Who can point me in a direction for find some crank shaft bearings and a connecting rod? Please help. Thanks
  6. P

    OPS80 Piston rod melt down

    Some time ago I was looking for information about the motor I purchased for my old mono. I believe someone stated something about the piston rod may give up. Well it did. I was trying to get some throttle control and I didn't get the cooling water running quick enough. Took the poor thing...
  7. P

    Tuned Pipe Clamp

    I am still working on this OPS80. The silicone tube that came with the header moves arronud. I have held it somewhat in place with wire ties. This doesn't look as if it would hold for verry long. Can I make or purchass something better? Thanks Pat.
  8. P

    Marine Nitro Motor

    Ok, it sounds like the OPS AE85002US is an ok motor if I glue in the carb and install a different piston rod. I know "BOAT" stands for "bring over another hundred" however I thought that was only for my 330SS. Now that that is off my chest what motor should I have purchassed? This will be...
  9. P

    OPS Carburetor poping off

    I am putting together this old mono hull that I started over 30 years ago. I purchased a OPS AE85002US .80 motor for the power. I had it almost complete and took it outside to do a bench run. I hooked us some water, fuel and everything else I could think of. Started the motor and started to...
  10. P

    Flex shaft bend

    After looking at the title I started with, I must hope your mind is on my RC boat. I have an old 42" deep V mono hull that I am installing a .80 OPS nitro motor in. Some think that the motor may be too large. Hope to find out this year. I would think that the best bend in the flex shaft is...
  11. P

    Radio Box Layout

    I know this should be so simple, however I don't like anything I have seen or tried to date. I am still rebuilding this old mono. I have come down to the switch to turn on the reciever in the boat. Is there a web page that may have several different layouts of the radio box. Does anyone have...
Back
Top