Recent content by sport hydro

Do to personal issues, I am selling the following items. All have not been used other than to set up the boat where they were to go. Leopard 4092, 930 mah. Selling as is: $ 75.00 plus shipping. ZTW 200Amp 4s-8s, $125.00 w/programmer plus shipping. TP4060-1650KV. $75.00 p/shipping. .250 36"...

This is now March, when do you think that you can get the race schedule out on IW?

I was planning to run in D-4. I used to belong to the Badger Club. So you are saying that I need to run a different motor but the ESC and batteries should be ok. So I can run the Leopard 4092 as long as it is 850KV.

So running the TP4060-1650KV motor on 2 4S 6000 Mah batteries through a ZTW 200A ESC will not work in my 1/8th scale.

Keep getting told to run a 57mm prop. What does that relate to with an octura prop number. I have a box of all sizes from my nitro days.

I ordered a pair of 6200mah batteries from RC Batteries. Got them in and they are too big and too heavy for my 1/8th scale. They are 6.1x1.88x1.69 in. I was told that 5000mah batteries would not last for racing. Who would carry batteries that are smaller in size but handle the MAH and race...

Sorry, I meant to give thanks to Off Shore Electric.

Got my order from Bill. Everything was great. He was very quick to get the order shipped out. I will be ordering from him again. I need to get the ESC and some other stuff.

If I put the TP 4060–860KV into my scale will I be allowed to run in D-4?

Yes.

Thanks, I wasn't sure. Offshore is out of the recommended motor for scale in IMPBA Dist. 4

I found this motor on Amazon. Would it work in a 1/8th scale application? Model: 4092/3D Max Amps: 140A Max Voltage: 20V Max Power: 4200W KV (RPM/Volt): 1730 Resistance: 0.0065 No-Load Current(15V) 4.5A Dimensions(mm): 39.8x92 Mounting Hole Depth(mm): 9 Shaft Length (mm): 20 Shaft...

What are the motors and Speed controller combos that are allowed. I was going to rebuild my miller boat. I had set it up when I was in Tx. The motor I was told I could use the Leopard 4092. The Speed controller was the 2TW Seal 200A 8S. I was using two 5000 MAH 4S in series.

Thanks, I thought it would be stronger. Was not sure if it would put strain on motor at launch.

I am converting my 1/8 th scale to electric. The drive shaft currently is .250". Do I keep it or change to the .1875" shaft?