Recent content by Scott Tonak

Hey Gary, I've had no troubles using Loctite plastic bonding, JB Weld plasticweld or any Cyanoacrylate for plastics. I can bring some out to you this weekend if we get together to finish up that lower unit. I got the bearing today!

Haulin A$$!! Well done! Come on Steve. You know. That prop is one of those ?*#!%.🙃

Yep. Just hydrodipped. Go to mydipkit.com and order a kit to diy. Lots of videos on youtube. I even dipped the whole top deck on my mono

Thanks Dan for the awesome boat! I dipped it. Fairly simple to do.

I put some fresh "lipstick" on her.

Great picture! A well set up Backlash is a very hard boat to beat in race water. Well done! Here's a pic of mine

Haven't seen any old Eddy Barns boats in a long time. That's a blast from the past! Back in the day they were good runners when set up well. Regarding the EZ start, it also depends on what engine and the thickness of the mounts you are using. I use Gizmo mounts and the EZ start kit from...

I really like the mounts that Steve made. However I would strongly suggest that you reinforce the bulkheads with some carbon cloth to better attach them to the bottom and sides. Especially because they are actually just single pieces of wood. Maybe even sandwich them with carbon plate. Also...

If you want a ready to race prop, contact this guy [email protected] Tell him what you got and get hooked up.

Turned out ok. I was able to work the flaws out of it.

Yikes! That's scary stuff right there. I was about to get started on this prop and saw these imperfections in the casting. Now I'm a bit nervous.😬

"Accelerates like a train" would be a hard pass for me. However, Mathe designs and builds exceptional engines.

BAR is the blade area of the prop. The higher the bar, the bigger the blade area. ABC has props that vary from .38bar to .75bar and 10* rake to 23* rake.

Looks like you got quite a variety there buddy. Any discount on the ones you're stepping on or do those actually cost extra? 😆Hands down the best prop work in the biz!

Get them by Monday from McMaster-Carr with standard shipping. If it's a Quickdraw Hotpipe the part # Dash #118 Silicone 1283N61 Viton 9464K82 If it's a different so called "Hotpipe" then you can find the size you need. Hard to beat their prices.