Recent content by MitchFarabaugh

I've used OSE plenty of times and always had good luck, but I refuse to buy from a company that doesn't even list a phone number. What a shame!

Probably not the best for engines, but there is NO Better coating for machine tools than Fluid Film.

It will likely not get "used" until spring, although I've bound one boat up and played with it a bit. It feels good in the hand, with a good bit of weight, can't say much beyond that really... everybody's different. As for ETX, it's kind of like Linux. If you've been using an Apple for 20 years...

I've been flying with one of their stick radios (TX16S) for the last 3 or 4 years. Fantastic radio at a great price, EdgeTX is insanely powerful. A bit of a learning curve, but you can do just about anything you can imagine. And with the 4-in-1 models, you can use just about any RX out there, no...

I just received one on trade. I was told they work very well, but need a bit of maintenance and the occasional new shaft (mine even came with a few). The videos he showed me were pretty impressive! Not a "race" motor, but should be great for a play boat.

Finally a definitive answer for this thread. I came across this for sale a few days ago and couldn't say no. BNIB. Not sure what I'll do with this one, but had to grab it when I saw it, as I/we may never see another brand new one again!

You do the same. I wanna see them both on the water!

That looks great, thanks for sharing. If mine works out it will be sporting some sort of obnoxiously bright colors with lots of flake - reminiscent of the 70's drag/river boats.

That looks killer. Did you design the mounts? Mine is very much a test to see how the pump holds up to the Zen. As far as I know I'll be the first to run one of these pumps with a gas engine. If it works and seems reliable, I'll tear it down for paint and "finishing", and then get started on my...

Hey! I've got one of those. I was told they were made in E WA, on the other side of my state, where I bought mine. Mine is sporting a 20cc Zen and a 3d printed jet pump, almost ready to maiden. I'd love some more info too if anyone has one Oh, and if you want to sell one, I've got another...

Pick up one of these https://www.amazon.com/gp/product/B000BYEJ02/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 (there are cheaper ones, but this one is built the best by a long shot) and some of these...

I use cut up silicone baking sheets... the kind your wife uses on top of her baking sheet for making cookies. They're very temp resistant, thin/lightweight, and reinforced with a fiber. If you use the 3M aluminum heat tape to hold it in place it works very well.

Anybody know why I haven't been able to find their site recently? Am I completely losing it?

Try BH Hanson?