Recent content by Mike Hughes

Joel Yeah I can do that. It will be a bit to get them done. Just to be sure the cowl height is 2 1/8. This is what the size of the abs cowl was when I pulled the mold. The newer style SGX is 1/4 smaller on height. If that is ok with your boat, then I can get going on them. The other mold will be...

Joel 17.25 oval from end of pipe shroud to the tip of the mold. The motor center is 10.5 from the tip of the mold. I have something in the works that will be longer. But it will be some time before that is available. Mike

Nice to see it get back in the water. Enjoy

My stuff will ship as well tomorrow

Just need address Tom. They are yours for the kid.

Yeah my V5 runs in the 75 range on my meter. I run 40-45 on my 80s.

Dustin, You lie. You have been saying that for years......

What motor size? What flow meter? Ideally, when motor is running on bench, there should be a slight hesitation when throttle is pulled full. You can get close using the techinque above. Then test, test, test. MIke

Tom, Left you a voice mail about a coil. Does he need a bag? I can send along some fuel line, nipples, and bag as well. Mike

You all have been asking.......well here it is. Now all you scanals can get you info from David. https://www.newtonmarine.com/

That was my first boat

Not 1/8 scale at 24" long. The boat is 1/16th scale which has not run since brushless has shown up. Mid 90s ish. Mike

Ronnie, Yours went out today. Thanks Mike

Like I said John, if you need any help modifying it. Let me know. Mike

Alex, Arne, Cowls are packed and going in the mail tomorrow. Thanks Mike