Recent content by Mark Stein

That I can probably do. I have a spin fixture I can set up for that. As long as it has 4 90 degree positions that. Kicking myself for not buying a lathe already

Thats the other end Mike😁

Prather large works for both. May want to add a fuel filter in the pipe pressure line to keep the odd clump getting in your needle

Wasnt aware of graves rc. Will check into it. This gets my current boats covered. But would like a couple spares. I was going to make my own but couldnt find a resonably priced rotary broach with an mt2 taper Even chinese ones were $400

Thanks Mike, These would be the first I bought from you but I will take them. Pm me with payment details

Timbo, I talked to Dave a few yrs ago. After a number of phone calls over 2 months. He was going to make them, then decided they were old school and wouldnt sell. I even offered to buy 20 that day before he made them, still no. Suprising is he still carries the 1/4" square ferrel. I bought a...

Thanks Mike, fingers crossed

Called Lenny but no luck for my type setup. He does however carry a square drive setup.

Anybody have any of these laying around they want to part with or can make them. tia.

I am serious I never even looked at this thread so wtf

Not sure why it says today.. was not even on this subject. Not sure what/why the site posted for me.. so glad they can post nonsense for me ... go intlwatersrc. Wow i am looking for some If I can get a few square drive ferrals if not ...well I am done with rc boats ..just a sad naritive on our...

Hyperformance said he would make them then changed his mind 3 times. Pointless waste of time making calls till he would answer then yes no res no. Blah blah blah

I run doble ended square drive and cant get the lower ferral for my boats. Basically gave up trying. Hyperformance used to sell them but wont make them after continually contacting him a few yrs ago over the period of a ydar. I finally gave up. Even after I said I would pay for 20 of them while...

Are odonnell plugs still bemeibgcm mdmade$ need to order soon"^&%#%@

Bill, sorry changed my mind on selling the motor. Job opportunity today will allow me to keep it. Been a tough year. Sorry again Mark