I could try let me know when and where if you want with it being thanksgiving. I cheeked the intake rotor and seems to only go on one way the othe hole is smaller than the crank pin. And doubled cheeked the last flow setting and was 50 on the flowmeter
Intake rotor in time not sure spinning counter clockwise and new plug pressure fitting is just before the fat part of the pipe
Will have to cheek the intake rotor.
Thanks for your input I have the third needle at 3 1/2 turns out and the low neddle setting backed out untill I see the first oring still no luck and tryed flow meter setting from 60-120 dont know if this helps