rebuild the 67

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
yes, that is a clean set-up there (love the KRE carb)

Is your .67DD part of the first batch? (I remember the 1rst release had clear anodized water-cooled head assy)

Also, what type of remote needle are you using?
 
hi david, is that brass piece in the middle of the t-bar for oiling the shaft?
 
Last edited by a moderator:
Ready for a very early run,time to start running hard now..CMB muffled pipe,hardened prop,and I think finally got the water flow down enough to get more heat,swapped out the water line for some 3/32" tubing and a soldered and drilled outlet nipple 0.60" .

IMG_20180512_185938.jpg
 
Great run so far ,,,lots of power ,turns the mod 2314 chopper easy at 11" on 60% ,added some weight for stability , next is the new 2317 to try on Sunday ..
 
Blew the dust off this Sunday and she was impressive..Gotta like the novas.

44902183_10205021534735106_1085060922545799168_o.jpg
 
Last edited by a moderator:
No probs thanks David ...this is with stock timing ..going to try a X462 mod  next..And also revisit the ABC 2317 option i havent tested properly..
 
Are we saying there is not much out there in a range of 67 mono props?

I’m just finishing a 67 mono 42inch seducer to compete in x mono.

looking for prop options
 
Are we saying there is not much out there in a range of 67 mono props?

I’m just finishing a 67 mono 42inch seducer to compete in x mono.

looking for prop options

Octura x457/3 or
Octura x462/2 are great props.
Contact Mark Sholund on here for prop work.
 
Back
Top