rudder backset on mono

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Mark Stein

Well-Known Member
Joined
Feb 19, 2003
Messages
539
Curious what the reason is for the rudder to to 6" from the transom on a gas mono. Is it just to help the boat turn better or does it help settle the boat in the straight. I have run them close and extended on my nitro monos in the past but never really understood why it is where it is
 
The turn fin and the keel of the hull dig into the water in a turn and the prop wants to drag the boat transom to the left. So, the further back the rudder the better the leverage to control all those factors. I have found that for example on a mono I used to run with no trim tabs that the closer to the transom the rudder was located the more it pushed the bow down to the water. It tripped the boat more so than when it was further back from the transom just dragging along. Most boat setups use trim tabs to accomplish the SAW attitude though and the rudder further back for controlling the boat in the turns. I am sure someone else might have other ideas, as I am just speaking from what I have found on my deep vee boats. I have found that running the rudder further back from the prop also helps control prop walk on my gas boats with the bigger props. On my old nitro mono hulls with the smaller props the rudder could be located beside the prop and worked just fine..

John
 
Last edited by a moderator:
if i could ask what also happens when the STRUT is father back?? does it make the hull act Longer and burry the nose? sorry to go off topic some..thanks,mike.
 
Mike. The further back the prop the more it pushes the bow down as the transom is the pivot point between the bow and the prop. The height of the prop off the water also makes a difference as does the lifting characteristics of the prop.
 
Thanks for the info. I have a Delta Force 45 sniper I plan to work on in the spring. Havent run a gas boat yet so all new experience.

Mark
 
Mike. The further back the prop the more it pushes the bow down as the transom is the pivot point between the bow and the prop. The height of the prop off the water also makes a difference as does the lifting characteristics of the prop.
hi john,thank you very much for the reply,mike.
 
Heres the running gear I make for monos.

Rudder offset is 6 inches from transom to center of the pin.

F0456F87-17AC-45E1-A84F-A361AF2714EE.jpeg

BA0BF879-483E-48ED-A945-C5D8954771EB.jpeg
 
Thanks Steve. Those look really nice and I like the idea with the water line. Just dont like the look of the rudder so far from the transom.

The Sniper I have is gonna see a few changes in the bottom and a bit different on the hardware. I have run nitro monos before but not gas. Going to try a similar setup to what I had on my first mono and see what happens. If it dont work I can always make the rudder extension longer.

If you always do what you always did......
 
Can let you know when I get closer to getting some hardware for it. Have a couple other projects in front of it.
 
Im getting ready to make running gear for riggers and hydro stuff.

And I do make one offs.
 
Last edited by a moderator:
Back
Top