geoffreysherrah
Well-Known Member
- Joined
- Dec 1, 2016
- Messages
- 99
Does anyone know how to setup this needle valve to a CMB 45 VAC for the first time? It's going into a JAE 45 GT
There 2 examples. That's where I put my needlesThanks for the advise. Does the servo arm get set at the closed off position? Maybe I should wait and learn how to install it when boat season starts.
THY ARE CARB THROTTLE ARM STOPS.J, What's the purpose of the wire ties on carb bell mouths?There 2 examples. That's where I put my needlesThanks for the advise. Does the servo arm get set at the closed off position? Maybe I should wait and learn how to install it when boat season starts.
So they don't over rotate.J, What's the purpose of the wire ties on carb bell mouths?There 2 examples. That's where I put my needlesThanks for the advise. Does the servo arm get set at the closed off position? Maybe I should wait and learn how to install it when boat season starts.
We know that. But he wanted a example of how they where mounted.Stu's new needles are red plastic not purple thoughs are the older Bob Violett needles. They are the same thing products.
That will work.The Stu Barr needle valve has been installed. This is the only way it seemed to work. Does this look right?
Thats where we run ours!The Stu Barr needle valve has been installed. This is the only way it seemed to work. Does this look right?
Enter your email address to join: