Gas Scale Cowls etc

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
1) 8255/ 85 Dominos Pizza and Winston Lobster from Phil Thomas

2) 79 Circus/ Squire from Don Mckay

3) T6 Bud from Jeff Snell

4)Smokin Joes/ Winston Eagle/ Emcor/ Close call from Rc Boat Company- Fits the Extreme Series 158 and 173 kits perfectly as they were designed together.

Mike
 
RC Boat Company also has the Newton 108 Cowl available. This cowl fits Mike's 108 kit perfectly. Steve will also have a glass version of the 108 hull available shortly.

I'll be sending the Thriftway Too plug and the '88 Oberto (capsule) and wing plugs to Steve after the holidays. He will have those available at some point in the future as well.

Fred
 
RC Boat Company also has the Newton 108 Cowl available. This cowl fits Mike's 108 kit perfectly. Steve will also have a glass version of the 108 hull available shortly.

I'll be sending the Thriftway Too plug and the '88 Oberto (capsule) and wing plugs to Steve after the holidays. He will have those available at some point in the future as well.

Fred
fred,

any plans to make a glass version of your gas scale 101-xxxx karelsen ?
 
Yes Dave, we plan to make that in glass as well. perhaps in 2015.
 
Mike,

That's the wing for the Winston Eagle?? Not the Winston Eagle "Lobster" It's OK I got them made now!! Will have the boat in the water in the next month and then hunting for a painter!!!!

Later!!

Pat
 
Hey guys , I have one of mike 's Winston eagle lobster boats gas kit and would love to get a cowl and wings for it . thanks for the help, Darrell Smith
 
I got my Cowl from Phil Thomas and it fits almost perfectly to the hull as I put it together.. The Graphics is the next obstacle.. I'm seeking out Wes Ellet he has a "Lobster" already running I want to know if he got his graphics from Mike McNight or not?? I have called Mike but he's shut down for Holidays and possibly selling the Biz?? Is Wesley the alternative for the graphics??

Later!!

Pat
 
What about front and rear wing sets? Or are these made from scratch?
There may be a set out west, You can make them using some 1/4 foam board covered with thin ply and hardwood stick for the leading edges. the top is cut at a 30 degree angle so the Horizontal sits on top.
 
Last edited by a moderator:
I have made many sets of wings using Greg Hahns method,you can find video in how to forum
 
Last edited by a moderator:
I made my Canard wings are made out of 1/8" ply and aileron balsa the verticals tail is ply in the middle with aileron balsa on both sides but the horizontal is 6 inches wide and they don't make ailerons that wide so I have to shape ply and 3/8" balsa.. Then I'm going to resin it all when bolted together!!

Later!!

Pat
 
Back
Top