Jump to content

Help Support IntlWaters by donating using the link above.


  • Please log in to reply
3 replies to this topic

#1 MartyDavis


    World Racer

  • Members
  • PipPipPipPipPip
  • 1,831 posts

Posted 29 March 2017 - 07:02 AM

Has anyone set up an anodizing system for our small parts?  I have always wanted to have the ability to anodize aluminum parts.


If you have please list the components and show some images if you will.



#2 John Beardslee

John Beardslee

    Club Racer

  • Members
  • PipPipPip
  • 963 posts

Posted 29 March 2017 - 08:09 AM

Hi Marty
You can do it at home if you are careful and are comfortable working with acid. Check online, there are a number of good informative articles. Supplies are reasonable priced.
Thanks John

#3 bermudadude


    Beginner Boater

  • Members
  • Pip
  • 167 posts

Posted 29 March 2017 - 03:47 PM




i did some research a while back cause i was gonna do it for myself but it got back-burnered.

i read that this place was kind of the best for do-it-yourselfer

#4 Terry Keeley

Terry Keeley

    World Racer

  • Members
  • PipPipPipPipPip
  • 5,350 posts

Posted 29 March 2017 - 06:06 PM

Hey Marty:


I did my own stuff for years until I found a shop that fit me in for a reasonable cost.


It's quite easy, lot's of stuff on line like this:




I used an aluminum camping pot, some aluminum wire and in the beginning a 12v car battery with an ammeter and a big variable resistor.  A power supply was easier to use later on.


You can buy good dye from Caswell:  http://www.caswellpl...ource=overture/ Some use food coloring but the real dye is better.  Also a proper seal will keep the dark color much better than just boiling in water or whatever.


Give it a shot!  :)