J jeff baham Well-Known Member Joined Aug 10, 2002 Messages 1,257 Jul 1, 2015 #1 how much does brad christy charge to make a piston to fit a sleeve looking to get one for a traxxas 3.3 sleeve
how much does brad christy charge to make a piston to fit a sleeve looking to get one for a traxxas 3.3 sleeve
J James montgomery Well-Known Member Joined Jun 12, 2012 Messages 1,054 Jul 1, 2015 #2 jeff y not buy just a new p/l for it they r only like 50 to 60 bucks for both ..what will u be useing this for.....i thought about puting one in a jae 12
jeff y not buy just a new p/l for it they r only like 50 to 60 bucks for both ..what will u be useing this for.....i thought about puting one in a jae 12
J jeff baham Well-Known Member Joined Aug 10, 2002 Messages 1,257 Jul 1, 2015 #3 james , for some reason the stock piston don't hold up to good when you tighten the head clearance on the traxxas 3.3 and it will go on a jato car
james , for some reason the stock piston don't hold up to good when you tighten the head clearance on the traxxas 3.3 and it will go on a jato car
W Walt Barney Well-Known Member Vendor Joined Dec 3, 2003 Messages 3,342 Jul 3, 2015 #5 Jeff, how far did you go and what % nitro. Walt Barney Tanks 2 U Walt's Hobbies
J jeff baham Well-Known Member Joined Aug 10, 2002 Messages 1,257 Jul 3, 2015 #6 stock timeing and 40 boat fuel
S shoboat Well-Known Member Joined Jun 23, 2002 Messages 7,407 Jul 3, 2015 #7 Jeff, I think Walt wanted to know what you had the head clearance set at? Any lean runs? Thanks, Mark Sholund
Jeff, I think Walt wanted to know what you had the head clearance set at? Any lean runs? Thanks, Mark Sholund
J jeff baham Well-Known Member Joined Aug 10, 2002 Messages 1,257 Jul 3, 2015 #8 head set at .008 with .020cc bowl the first piston the bottom of piston shattered and the second piston yes the carb poped out Last edited by a moderator: Jul 3, 2015
head set at .008 with .020cc bowl the first piston the bottom of piston shattered and the second piston yes the carb poped out
Alan Elzer Well-Known Member Joined May 21, 2006 Messages 1,629 Jul 5, 2015 #9 Jeff Get with Rick @ RBMODS he does a lot of engine work with those motors. He's on facebook. I have his phone contact if you need it.
Jeff Get with Rick @ RBMODS he does a lot of engine work with those motors. He's on facebook. I have his phone contact if you need it.