Drive shaft

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Pond Player

Active Member
Joined
Mar 15, 2002
Messages
28
I was wondering I was trying to install a drive dog and dogbone to a drive shaft but its compleatly round. Should I file a flat spot where I'm going to tighten the screw down or just leave it and tighten it???????
 
Nick,

I file a flat spot on the shaft using a Dremel and a cutting disk. Without that, the drive-dog would turn on the shaft under load.

Marc Paulais, Paris France
 
Back
Top