Jump to content



Help Support IntlWaters by donating using the link above.
Photo

GSX 310

Set-up Props rudder strut

  • Please log in to reply
3 replies to this topic

#1 Buoyhunter

Buoyhunter

    Boater

  • Members
  • PipPip
  • 281 posts

Posted 28 May 2017 - 04:32 PM

Attached File  IMG_20170508_185053253.jpg   90.18KB   6 downloadsGetting close to having the hull built. looking for the best set-ups for a electric P limited. what depth is the strut? what side does the rudder go on? how much battery capacity do I need? Do I need 65C discharge batteries? how big does the turn fin need to be?




Edited by Buoyhunter, 29 May 2017 - 08:24 AM.


#2 brad nichols

brad nichols

    World Racer

  • Members
  • PipPipPipPipPip
  • 1,591 posts

Posted 28 May 2017 - 04:44 PM

Rules will tell you the motors that are usable for P- Limited. 4S 50000  for batteries, the higher the C rating the better if all out race boat. Speedmaster hardwareand I put the rudder on the right sidw. Mike at ML has a turn fin available.

 

Brad





#3 darryl whitman

darryl whitman

    Beginner Boater

  • Members
  • Pip
  • 225 posts

Posted 30 May 2017 - 08:02 PM

HI , I have a older sport 20  310 from ML . nice boat . I have a 120 amp esc, with 2 2cells 5000mah batts , powering a NEU 2200kv Motor.

for the strut setting , place the boat on a flat table raise the rear of the boat till the bottom is level, and start with that. also I had to 4 oz of lead 

to the nose. Also I Launch the boat like it was a nitro boat to get it up on plan fast, Make sure you run Caps on your ESC to help with start ups.

The rudder , just buy a SM 20 size,,,, 

in 2014 at the minute breaker classic , in Mendota, il , I placed 2 nd . my 1st year of rc boat racing

Thanks to good friendly people in this hobby . Darryl



#4 Buoyhunter

Buoyhunter

    Boater

  • Members
  • PipPip
  • 281 posts

Posted 26 June 2017 - 11:27 AM

Still working at completing this project. Need to beef up the right sponson transom with some aluminum and put the upper skin on it then completely seal up the hull...

Maybe through some paint on it later. 

Attached Files


Edited by Buoyhunter, 26 June 2017 - 11:28 AM.






Also tagged with one or more of these keywords: Set-up, Props, rudder, strut