Futaba 3PM-MX set up issues

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

GeorgeAlbrecht

Well-Known Member
Joined
Sep 14, 2014
Messages
234
Guys I need help I got the radio to work on model 1 but don't know how to pair receiver and set up the other models. Video links would be a great help but anything would be great.

Thanks
 
Phil thanks for the reply. I have the manual but every time I pair a receiver it goes to model 1 I don't see any where in the manual about how to pair the receiver with the other model numbers
 
Once you get the TX to model #2 are you pressing the +&- buttons to set it to model 2?

Once you do that, turn TX off, then back on it "should" be at model #2 still. Once that is done, turn on RX and press bind button untill green light stays on.

Shut everything off then back on, green light should still be on and TX should be on Model #2.
 
Phil thanks for the reply. I have the manual but every time I pair a receiver it goes to model 1 I don't see any where in the manual about how to pair the receiver with the other model numbers
Well it dont care what model # it is on it binds the receiver and transmitter. You should be able to run all model numbers with out pairing or binding again.
 
Phil,

Futaba Fasst does not trans/receiver bind to model individually. It is not like a Spectrum.

All model numbers will work as many receivers as you have bound to the transmitter regardless of what model it was on when receiver was bound.

You can run them independently on whatever model setting you have the radio on and always stay bound. No rebinding necessary.

Set the transmitter to the model settings of the model you are using and make SURE you shut the others off. Turn on the transmitter and the model and you are done and ready.

The receivers are all bound to the transmitter.

You can bind all receivers to the transmitter while on any model number and then they will work on any other model number the same except of course it uses all your settings for each individual model you are set on.

Once they are bound/paired they will function on any model number you set the transmitter on and they stay bound unless they are rebound to another transmitter.
 
Last edited by a moderator:
Thanks Daniel for your explanations. I'm having a problem with the HRS fail safe feature. When all is set when the TX or RX are turned off should the throttle servo move to the preset position, low speed. I can't seem to get it to work. Yes I'm using the book. Thanks Tim
 
Back
Top