Don Templeton
Well-Known Member
- Joined
- May 13, 2002
- Messages
- 1,155
Hello: I'm back again!
My 12 rigger is comming along well but I could sure use some suggestions on set up.
My front sponsons are set at 9/16" depth at inside rear edges.
What depth should I set the bottom of the rear sponsons at and
the bottom of the 5/16" OD strut to start with? Also, should I
add any up angle to the strut like maybe 2 degrees?
The hull is 23-1/2 x 3, the rear of the front sponsons are about
9" from the nose, the center line of the OS 12 TR is about 8-1/2
back from the nose, the rear of the strut is only 1/16 back from the
transom. The stub shaft is 3/16 with .130 flex. The boat is light
ply but may be a little heaver than some I have been hearing about.
Probably over 2-1/2 lbs but not sure at all yet.
I know this will be a guess but any advice to look at would be
helpfull, especially the depth of the rear sponsons.
Thanks
Don :-
My 12 rigger is comming along well but I could sure use some suggestions on set up.
My front sponsons are set at 9/16" depth at inside rear edges.
What depth should I set the bottom of the rear sponsons at and
the bottom of the 5/16" OD strut to start with? Also, should I
add any up angle to the strut like maybe 2 degrees?
The hull is 23-1/2 x 3, the rear of the front sponsons are about
9" from the nose, the center line of the OS 12 TR is about 8-1/2
back from the nose, the rear of the strut is only 1/16 back from the
transom. The stub shaft is 3/16 with .130 flex. The boat is light
ply but may be a little heaver than some I have been hearing about.
Probably over 2-1/2 lbs but not sure at all yet.
I know this will be a guess but any advice to look at would be
helpfull, especially the depth of the rear sponsons.
Thanks
Don :-