- Joined
- Dec 25, 2008
- Messages
- 97
anyone familiar with AC boats sport 40 hydro ?? need setup help thank you
sport 40
- Thread starter mike menter sr
- Start date
Help Support Intlwaters:
- Joined
- May 10, 2010
- Messages
- 3,005
Had one and sold it to another boater but you can email Andy at AC Model Boats and he can send you the info. There is a second version of this boat that is easier to launch.Brian Tooms on here has one that runs well and he may have the info or can measure his.
Brad
Brad
- Joined
- Dec 25, 2008
- Messages
- 97
- Joined
- Dec 25, 2008
- Messages
- 97
thanks brad not sure of which version but i bought off estate sale so this old gasser is going with sport 40 and 1/8 lol
- Joined
- May 10, 2010
- Messages
- 3,005
Found my instructions. Strut set-up raise the hull up so it is 1 1/2" off the table and push the strut down so it is flat on the table. I could send a copy of the info if you send me your address as I have a set for the original boat also. They are a good running boat. Strut location is different between NAMBA and IMPBA.
Brad
Brad
- Joined
- Dec 25, 2008
- Messages
- 97
thanks brad my address is mike menter 60 dunston ave buffalo ny 14207
- Joined
- May 10, 2010
- Messages
- 3,005
I will get them out next week.
Brad
Brad
- Joined
- Jul 9, 2009
- Messages
- 275
I just checked my boats, (I have an FE version as well) and from the bottom of the boat to the bottom of the strut is 1 1/8" with a bit of negative angle. My struts are under the boat as per Namba. If there's any info you need glad to try and help.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
- Joined
- Dec 25, 2008
- Messages
- 97
- Joined
- Dec 25, 2008
- Messages
- 97
thanks brian will let you know
- Joined
- Dec 25, 2008
- Messages
- 97
