- Joined
- Oct 25, 2004
- Messages
- 1,130
I have an unused CMB 45 VAC on my shelf that will not be used.
This is a 180 degree engine ment for gear drive, which means most of you haven`t seen it before.
But the internal parts are the same as a direct drive, which means you can do a total rebuild of your worn out VAC 45 at a very decent price.
(pinion gear in picture is not included as it follows the gearbox)
I`m asking for $300,- PP as FF, insured shipping is 40,- without insurance and without tracking is 10,-
Parts for CMB 45 HR (new)
Conrods x 2
Needles x 2
Drums x 2
Crankshaft x 4
Price is $200,- PP as FF
All questions to be posted in this thread.
First to post "I`ll take it" gets it.
This is a 180 degree engine ment for gear drive, which means most of you haven`t seen it before.
But the internal parts are the same as a direct drive, which means you can do a total rebuild of your worn out VAC 45 at a very decent price.
(pinion gear in picture is not included as it follows the gearbox)
I`m asking for $300,- PP as FF, insured shipping is 40,- without insurance and without tracking is 10,-
Parts for CMB 45 HR (new)
Conrods x 2
Needles x 2
Drums x 2
Crankshaft x 4
Price is $200,- PP as FF
All questions to be posted in this thread.
First to post "I`ll take it" gets it.
Last edited by a moderator: