RichardKnox
Well-Known Member
- Joined
- May 9, 2010
- Messages
- 124
I have a Phil T. Sport 40 with a Klass Kote paint job I want to remove. Can I use a stripper on it or do I have to sand it off?. Thanks
This hull is done inside -outside and on the bottom. Thick coats and then cleared. I want to get it back to the gel coat white. Is sanding the lone option?A lot of paint strippers I have tried over the years will soften both polyester and epoxy resin. In fact, I have used paint stripper to undo an epoxy joint. (it soften the epoxy glue to a point where I can just scrap it off), I wet sand all my boats when I want to refinish.
Enter your email address to join: