The Bullet outriggers have stepped up the game in TFH.That's bad ass went to Augusta to watch the top fuel boats. And it was super cool looking at full size riggers with giant fire breathing motors
Been doing a lot of full size this summer. Just one full size racer adding out rigger tech to there design and race equipment..
Been following it on Scream and Fly, Chuck . the effort in this project is OFF THE CHAINI don't have all the details but the boat is a one of build for MONTYS Racing... There is a Tubular frame under that. You can all the pic of the boat and the motor a V-8 on face book.
look under Monty Racing.....He is mercury killer that Foley makes sure not to line up against.....:lol:h34r:
Building an rc version of twisted!Been doing a lot of full size this summer. Just one full size racer adding out rigger tech to there design and race equipment.....
It is not supposed to be mounted that way but everyone has there own ideas.It's interesting that the skid fin is attached on the outside of the sponson. [Or on the outside of the part of the sponson that stick out and to the rear and above the sponson's running transom] Has anyone tried this on a model rigger with any success?
it would be worthwhile to try it might be able to put less bend in the finIt is not supposed to be mounted that way but everyone has there own ideas.It's interesting that the skid fin is attached on the outside of the sponson. [Or on the outside of the part of the sponson that stick out and to the rear and above the sponson's running transom] Has anyone tried this on a model rigger with any success?
Enter your email address to join: